Tigertronics - SL-USB
- Customer Comments
- Customer Reviews
*** PLEASE NOTE EACH UNIT IS SUPPLIED WITH ONLY 1 LEAD OF YOUR CHOICE.
ANY ADDITIONAL LEADS WILL REQUIRE AN ADDITIONAL PAYMENT BEING TAKEN FROM YOUR ACCOUNT ***
Once again Tigertronics sets the pace in digital operating! The new SignaLink<™> USB combines the legendary performance of our SL-1+ with a state of the art "built-in" low-noise USB Sound Card. This ground breaking innovation delivers optimum performance while eliminating the need to attach to your computer's existing sound card.
- Built-in Low-noise Sound Card
- Simple Installation and Setup
- Complete Radio Isolation
- USB Port Powered
- Works with ALL Radios
- Uses Mic, Data, or Accy Port
- Supports All Sound Card Digital and Voice Modes
NOTE: The SignaLink<™> USB needs a cable to suit your radio. Please select the cable from the product accessories list above or the acessories link below. A jumper module may also be added as an optional accessory to ease configuration, especially if the Signalink is to be used with more than one radio, although these jumper modules are not essential because a set of jumper leads are provided with the SignaLink<™> USB
Power Supply: USB Port Powered
Audio Freq Response: Approx. 300Hz - 3.3Khz @ 600 ohms
Sampling Size/Rate: 16 Bits, All standard rates are supported up to 48Khz
Computer OS: Windows 98SE, ME, 2000, XP, Vista, Windows 7 & Windows 8
MAC OS 9.1 or later
MAC OS X 10.00 or later
Computer Hardware: This depends on the program that you are running
(see your program's Help or ReadMe file for details).
Most communications programs run fine on a 266Mhz
or faster Pentium type processor, but some may require
a faster computer.
Radio In/Out Z: 600 Ohm (nom). TX/RX Levels are fully adjustable for
compatibility with Hi-Z and Low-Z radio connections.
Auto-PTT™ Delay: Adjustable Transmit "Hang Time", 30 ms to 3 seconds
PTT Circuit: Relay
Rating - 1AMP (max)
Radio Connector: TX Audio, RX Audio, PTT, GND - RJ-45
RX Audio/Speaker - 3.5mm Mono
Computer Connector: USB 1.1/2.0 Compatible
Standard USB "B" type connector
Other Connectors: Aux. Speaker - 3.5mm Mono
Case: Extruded Aluminum - 6061T4
Dimensions/Weight: 1.6" x 3.2" x 3.6", 6.6 Ounces
Operating Temp: -30C to +60C
I would just like to express my sincere thanks to everyone there for all the help, advice and service over the last year since I became Licenced, but I would like to say a special thank you to Paul, who, despite my frustration, has done me a great service.
Having purchased the Yaesu SCU-17 interface and not managing to get it to work, and on advice from a friend, wanted to send it back and get instead, the Tigertronics Signalink, as this model was tried on my rig and worked perfectly straight away. So upon contact with Paul at the shop, I explained the whole thing and to be honest, expected that unless the Yaesu proved to be faulty, that there was little help I would get, but, to my delighted surprise, Paul said, ok no problem, we can sort that out for you, just send it back with a cover note to explain what we are going to do, and we will get one packaged up and sent out for you.... What’s more, Paul and I managed to work it so we would be square on the cost.
Many, many, many thanks.