LDG AT-600Pro11

Time was, 100 watts was a lot of power. Today, more and more mid-sized amps with 500 watts output are becoming popular. The LDG AT-600ProII is designed for this new generation of power levels.  

The AT-600ProII will handle up to 600 watts SSB and CW and 300 on RTTY (1.8 – 30 MHz) and 250 watts on 54 MHz. It features LDG’s state-of-the-art, processor-controlled Switched-L tuner. It will match virtually any kind of coax-fed antenna, including Yagis, dipoles, inverted Vs, slopers, loops, just about anything. It will typically match a 10:1 SWR down to 1.5:1 in just a few seconds. You can also use the AT-600ProII with long wires, random wires and antennas fed with ladder line just by adding a balun. It will also interface with the excellent new M-600 4.5" external meter.  LDG have also added 2 LEDs on the front panel.  One to show if the unit is in bypass and one to show if you have Ant 1 or Ant 2 selected.

 
PICTURE ABOVE IS SHOWING THE AT-600PROII WITH THE OPTIONAL M-600 EXTERNAL METER.

The AT-600ProII will handle up to 600 watts SSB and CW and 300 on RTTY (1.8 – 30 MHz) and 250 watts on 54 MHz. It features LDG’s state-of-the-art, processor-controlled Switched-L tuner. It will match virtually any kind of coax-fed antenna, including Yagis, dipoles, inverted Vs, slopers, loops, just about anything. It will typically match a 10:1 SWR down to 1.5:1 in just a few seconds. You can also use the AT-600ProII with long wires, random wires and antennas fed with ladder line just by adding a balun. It will also interface with the excellent new M-600 4.5" external meter. LDG have also added 2 LEDs on the front panel. One to show if the unit is in bypass and one to show if you have Ant 1 or Ant 2 selected.

Cycle 24’s not going anywhere any time soon. If you power up, LDG’s got your back with the new AT-600ProII. Order yours today.

· Easy to read LED bar graph display for RF power, SWR and status

. Optional M-600 4.5 inch analog meter.

· 4,000 memories for instantaneous band changing

· Two position antenna switch with memories for each position

· Tuning time: 0.5 to 6 seconds full tune, 0.1 second memory tune

· Built in frequency counter for memory operation

· Frequency coverage: 1.8 to 54.0 MHz.

· Tunes 6 to 800 ohm loads (16 to 150 ohms on 6M)

· For Dipoles, Verticals, Vs, Beams or and Coax Fed Antenna

· Includes DC power cable.

· Power requirements: 11 to 16 volts DC at 750 mA max during tuning

   www.Jameco.com WM1024-760 and 1953663 are compatible power supplies

· Enclosure: 10.5D x 8.5W x 2.5H inches