The mAT-125E is a versatile automatic tuner, which can be used in almost all types of transmitter.It provides automatic antenna tuning across the entire HF spectrum plus 6 meters, at power levels up to 120 watts. It will tune dipoles, verticals, Yagis, or virtually any coax-fed antenna. The mAT-125E will match an amazing range of antennas and impedances, far greater than some other tuners you may have considered, including the built-in tuners on many radios.
The mAT-125E has 16,000 frequency memories. When tuning on or near a previously tuned frequency, the mAT-125E uses "Memory Tune" to recall the previous tuning parameters in a fraction of a second. If no memorized settings are available, the tuner runs a full tuning cycle, storing the parameters for memory recall on subsequent tuning cycles on that frequency. In this manner, the mAT-125E "learns" as it is used, adapting to the bands and frequencies as it goes.
The tuner does not require a data cable to be connected, but only a 50 ohm RF cable to the transmitter.
USB C charging connection. The mAT-125E contains two 18650 Li batteries, which do not need external power supply, this makes it easy to use mAT-125E especially for portable activations. Uses latching relay that operates for a very long time when charged.
Before you use the tuner for the first time after you receive it, the tuner needs to be charged, for at least 4 hours, to activate the internal battery protection circuit. During transportation, the tuner is in a protective state and cannot be turned on unless you charge it. You need to do the same after you change the battery.
USB C charging lead included.
*** 30 Watts maximum on Data Modes ***