We use
cookies and similar technologies
to help give you the best experience on our site and to show you relevant advertising. If you continue to use this site, we’ll assume that you’re happy to receive all cookies
MicroHAM USB micro2R (u2R)
SKU Part Number:
MHAM-U2R
USB micro2R (u2R) THE two-radio controller for everyday & contest use.
micro2R™ is designed for any amateur...
Read More
Read More
£299.95
£249.96
Pre Order
Seen this product cheaper elsewhere?
Call 0345 2300 599 USB micro2R (u2R)
THE two-radio controller for everyday & contest use.
THE two-radio controller for everyday & contest use.
micro2R™ is designed for any amateur with two transceivers and any control interface. It is feature rich but easy to install and operate, provides automatic or manual control of headphone audio and transmitter selection, and is compatible with the automatic modes of all of the most popular contest logging programs.
micro2R™ is two radio controller for the single operator (SO2R controller). Install the control/driver software, connect your headphones, paddle, mic, footswitch and connect micro2R™ to your radios: you're ready to go. The front panel is easy to understand with pushbutton controls for headphone audio and transmitter selection, speed control for the built-in WinKey 2 keyer, separate soundcard drive controls for each transmitter, an easy to use mix level control, and clearly visible LEDs to indicate manual or automatic operation, headphone audio source, and selected transmitter.
Unlike any other commercially available SO2R solution (except MK2R™ and MK2R+™ from microHAM),micro2R™ uses either USB or LPT control, includes a proven WinKey 2 CW keyer, support for either electret or dynamic microphones, a UART compatible FSK port for each radio, and built-in support for the voice keyer capabilities of the most popular contesting software.
Features
General:
- advanced (USB) or classic (LPT) control
- proven microHAM Control Protocol
- "Band Data" or Antenna Relay ports controlled by logger
- two UART compatible FSK outputs
- single foot switch operation
- "selected transmitter" output for station automation
- compatible with most standard Windows based programs
- optically isolated USB and LPT inputs
- compatible with LPT interface (CT, TR, NA)
Keying:
- intelligent keying lockouts for both radios
- hardware lockout for ”last one wins” or ”first one wins”
- programmable PTT Lead and Lag adjustable in 1ms steps
- separately sequenced keying outputs for LNA bypass
- separate PTT per transceiver with automatic focus control
- support for VOX and CAT T/R switching command
CW:
- integrated K1EL WinKey2™ with front panel speed control
- front panel speed control.
- nine (9) memories with auto-numbering
- PS/2 keyboard/keypad support for direct CW with type ahead
- PS/2 keyboard/keypad support for CW message playback
- PS/2 keyboard/keypad CW works without computer connection
Voice:
- front panel headset jacks
- selectable electret bias (+8V) on mic tip or ring
- wide range preamplifier supports both dynamic and electret mics
- microphone switching allows "through the soundcard" or "soundcard override" operation
- transceiver PTT input for correct headphone switching in VOX
- nine (9) memory software DVK
Audio:
- front panel headphone jack
- passive receive audio with selectable transformer isolation
- support for second sound card for audio review
- front panel control knob for left/right audio ”mix” feature
- dedicated controls for ”classic” audio control (R1/BOTH/R2)
Other:
- support for dual dual BCD band data or antenna relay outputs
- integrated chokes and filters for maximum RFI immunity
- Metal/Aluminum case, powder coated and silk screened
- no time limit firmware/software upgrade on-line
Specifications
USB: USB 2.0 Full speed, USB 1.1 compatible
Power consumption:
USB – less than 100mA
Power supply – less than 250mA at 13.8V (max. 16V)
CW: 2 x open collector, max 30V/400mA
PTT: 2 x open collector, max 30V/400mA
PTT IN: 2 x active when closed to ground, max +25VDC only
ACC: TTL levels - 4mA Max.
LPT port: optically isolated, load less than 1 mA at 5V.
FSK: 2 x open collector, max 30V/400mA
FOCUS: open collector, max 30V/400mA - low = R1 selected
Foot Switch: active when closed to ground, max load: 1 mA at 5V
Phones: stereo output for headphones, 32 Ohm nominal
MIC: dynamic/electret selectable - max input 500mV
3dB bandwidth: 200 Hz - 6KHz typical
selectable 8V bias - 1mA max, off/tip/ring
SC Out: AC coupled input from soundcard - 32-600 Ohm, 4V p-p max.
SC In: AC coupled output to soundcard mic - 600 Ohm typ, 500mV P-P
3dB bandwidth: 200 Hz - 6KHz typical
Dimensions: W 232mm (9.125") x H 44mm (1.75") x D 101mm (4.125")
Weight: 1.3 kg (1.875 lbs.)
Note: Windows 98 (all versions) is not supported. Powered byShopFactoryPower consumption:
USB – less than 100mA
Power supply – less than 250mA at 13.8V (max. 16V)
CW: 2 x open collector, max 30V/400mA
PTT: 2 x open collector, max 30V/400mA
PTT IN: 2 x active when closed to ground, max +25VDC only
ACC: TTL levels - 4mA Max.
LPT port: optically isolated, load less than 1 mA at 5V.
FSK: 2 x open collector, max 30V/400mA
FOCUS: open collector, max 30V/400mA - low = R1 selected
Foot Switch: active when closed to ground, max load: 1 mA at 5V
Phones: stereo output for headphones, 32 Ohm nominal
MIC: dynamic/electret selectable - max input 500mV
3dB bandwidth: 200 Hz - 6KHz typical
selectable 8V bias - 1mA max, off/tip/ring
SC Out: AC coupled input from soundcard - 32-600 Ohm, 4V p-p max.
SC In: AC coupled output to soundcard mic - 600 Ohm typ, 500mV P-P
3dB bandwidth: 200 Hz - 6KHz typical
Dimensions: W 232mm (9.125") x H 44mm (1.75") x D 101mm (4.125")
Weight: 1.3 kg (1.875 lbs.)
Requirements:
Minimum - 1.6 GHz IBM PC compatible computer with Windows 2000, 512 MB RAM, Sound card, CD-ROM, USB1.1 port, Transceiver (x2), logger or control software (any)
Recommended - 1.6 GHz PC with Windows XP or higher, 1 GB RAM, Sound Card, CD-ROM, USB2.0 port, Transceiver with computer port (x2), CW paddle, PS/2 keypad, logger or control software (any)
Minimum - 1.6 GHz IBM PC compatible computer with Windows 2000, 512 MB RAM, Sound card, CD-ROM, USB1.1 port, Transceiver (x2), logger or control software (any)
Recommended - 1.6 GHz PC with Windows XP or higher, 1 GB RAM, Sound Card, CD-ROM, USB2.0 port, Transceiver with computer port (x2), CW paddle, PS/2 keypad, logger or control software (any)
Shipping:
We have several shipping options for our products, including next-day and Saturday/Sunday delivery for certain items. Please see these options at checkout.
Returns:
If you have any equipment that needs to be returned to Martin Lynch & Sons, please fill out the form below:
Upon receipt of goods you have 14 days to return goods however the goods must be returned in original packaging and care must have been taken with the goods you wish to return. Under distance selling regulations you are not entitled to any refund on carriage charges or modification charges made at your request.
Warranty Terms and Conditions
Outside of the 14 faulty return period, returned items cannot be accepted, unless covered by manufacturer's warranty. We will repair as much as possible on site however in exceptional circumstances products may have to be returned to the manufacturer of distributor.
For repairs/replacements under manufacturer’s warranty for any item please download a ML&S return form from the link above and return to ML&S with the faulty product.
International Warranty information
Warranty service for items we sell is available in the U.K. only, unless otherwise noted. It is your responsibility to pay freight for returned items to the U.K. and back to you for desired warranty coverage. All of our NEW products come with a minimum 12 month warranty, (Yaesu & Icom 24 months), with up to 90 days on second-hand equipment. Items returned for service must state "returned goods for repair" on the return air waybill or U.K. import customs duties apply and will be added to your invoice. For more info about returning items please contact our customer help desk, [email protected]