QRM-Eliminator
Product Information
- Overview
Problems with local QRM on short wave? Very often the answer to this question is a clear 'YES'. Those living in rural areas know how 'clean' the frequencies can be - except maybe the near-by high-power land line makes noise...
Additional data:
Dimensions: 200x130x56mm
Terminals: 3xUHF connectors for TX, base station and auxiliary antennas, 1 x Cinch jack for PTT and 1x jack socket for power supply
Power supply: 12V/150mA.
However, most interferences are caused by local electronic sources, like TV's, computer, bad connections.
With this new accessory you can get rid of local interference up to an S9 level almost entirely; the result is a clean QRG! You don't have to know what kind of a interference is present neither would you have to have knowledge about the location of the interference. It doesn't matter if the interference originates from the own Packet station of from a welder 100 meters away.
The QRM Eliminator is inserted into the feedline from the trx to the antenna without any additional modifications required to the radio. The box has a built-in PTT control which enables the Eliminator to stay connected during transmit. An additional auxiliary receiving antenna is required, though, like a 2m antenna or simply a couple of meters wire in the shack.
The unwanted signal is received with both antennas resulting in different phases. The QRM Eliminator now allows to adjust the phase angle as well as amplification in a way to cancel out the unwanted signal before it reaches the receiver front end!
It's based on a totally innovative concept and cannot be compared to the normal 'noise blanker' performance.
The QRM Eliminator is built into a shielded metal enclosure, functions over the frequency range of 3.5 through 60 MHz, and has a status LED to indicate when the unit is turned on for phasing. The unit has a built-in T/R relay with PTT control via a rear panel RCA phono connector for the transceiver amplifier keying line. The QRM Eliminator automatically switches the Main antenna connection to the transceiver during transmit. Also, simply turn the unit off to bypass the phasing unit for normal reception on the Main transmit antenna.
The QRM Eliminator is built into a shielded metal enclosure, functions over the frequency range of 3.5 through 60 MHz, and has a status LED to indicate when the unit is turned on for phasing. The unit has a built-in T/R relay with PTT control via a rear panel RCA phono connector for the transceiver amplifier keying line. The QRM Eliminator automatically switches the Main antenna connection to the transceiver during transmit. Also, simply turn the unit off to bypass the phasing unit for normal reception on the Main transmit antenna.
Additional data:
Frequency Range: 3.5 to 60 Mhz
Built-in T/R relay handles 125 watts RF
Dimensions: 200x130x56mmTerminals: 3xUHF connectors for TX, base station and auxiliary antennas, 1 x Cinch jack for PTT and 1x jack socket for power supply
Power supply: 12V/150mA.
Recently Viewed
- Digital Voice & DSP Noise Reduction£149.95(Inc VAT at 20%)