Ameritron ALS-500MRXCE Amplifier

Ameritron ALS-500MRXCE Amplifier
Part Number: ALS-500MRXCE
£1289.95 ( £1074.96 EXC. VAT )
Not Available to Order
Shipping to:
Add to cart
Call Now
Product Information
  • Overview
  • Description
We don't stock this product. Contact us for a better alternative. 

Get up to 500W PEP output from this solid state compact unit measuring 90 x 229 x 380mm. Directly driven from any 100W transceiver, and the solid state design means no tuning is necesssary and there is almost six times the power advantage.The unit can be remotely controlled for boot mounting with the supplied ALS-500RC remote controller.

1.8 - 30MHz (All Ham bands) - Output: 500W PEP (400W CW) - Input: 50 Ohms 60W (typ) 100W (max) - Output Devices: Transistor 4 x 2SC2879 - Meters: Current meter 0-100A - Connectors: SO-239 - Keying: Relay closure or sinking to Gnd 12V - Supply: 13.8V DC - 2.43m (8ft) power cable supplied - Size: 393 x 220 x 95mm - Weight: 3.4kg c/w ALS-500RC remote controller
Ameritron mobile no tune Solid State Amplifier

AL-500MRXCE is a combination of the CE certifed AL-500MXCE and an AL-500MRXCE Remote, for 240V export.

-Mobile no tune Solid State Amplifier - uses four rugged 2SC2879 high power linear RF power transistors.

-Instant bandswitching, no tuning, no warm up - just turn on and operate - makes mobile QSOs safer.

-Very Compact - Just 3 ½" x 9" x 15" - fits in nearly any mobile installation; weighs only 7 pounds.

-Extremely quiet - quiet low speed, low volume fan stays off and silent until temperature rises.

-Output Power - 500 watts PEP, 400 Watts CW

Continuous Coverage - 1.5 to 22 MHz 10/12 Meters with easy to install optional kit.

-Load Fault Protection - disables and bypasses amplifier if antenna has excessively h high reflected power or if bandswitching is set lower than exciter frequency - virtually eliminates damage because of operating error; has Load Fault LED indicator.

-Thermal Overload Protection - disables and bypasses amplifier if temperature is excessively high; automatically resets when temp drop to safe level Thermal Overload LED indicator.

-Excellent harmonic suppression - multiple section output network, push-pull output circuit has excellent harmonic suppression.

-DC current meter lets you monitor collector current.

-ON/OFF Switch - bypasses amplifier for "barefoot" operation without having to disconnect high current power supply cables.

-Remote ON/OFF Control - lets you remote control ON/OFF function for out-of-the-way mounting of amplifier.

-Exciter Drive - less than 100 watts input gives full output.

-Power Supply Requirements - requires 14 VDC at 80 amperes peak current for PA transistors and separate line for 14 - 16 VDC at 4 amperes for control and bias circuits. Made in USA.
Recently Viewed
If you’d like us to let you know as soon as this product comes back into stock, please enter your email address and mobile number below.