Nanovna-F_V2 3G Mini vector network analyzer

Nanovna-F_V2 3G Mini vector network analyzer
Part Number: MYDEL-JNCRADIO-VNA
£149.95 ( £124.96 EXC. VAT )
ESTIMATED SHIPPING COST:
£5.95
In Stock
Shipping to:
Add to cart
Call Now
Product Information
  • Overview
Click the play button above to watch the product review!

NanoVNA-F_V2 is a new generation of portable, stand-alone vector network analyser with 4.3″ IPS LCD screen, metal enclosure, 5000mAh rechargeable battery (continuous operation for 7 hours low-power design) Based on edy555’s NanoVNA and OwOComm’s S-A-A-V2 you can expect superb performance from a small, incredibly affordable instrument that will cover 50Khz to 3GHz.

The VNA is fitted with SMA connectors for easy adaption to the connector of your choice, please see accessories for our range of adapters.

The NanoVNA-F V2 comes in a suburb looking display, storage box that has a foam inlay to keep this lovely device out of harms way when not in use.

All in all this is a great value product punching way above its weight, grab one while you can these will go fast!

*** It is important to discharge any static from your antenna system before connecting any VNA / Analyser ***

Specification

  •          Frequency range: 50kHz ~ 3GHz
  •          S11 dynamic range: 50dB(50kHz ~ 1.5GHz), 40dB(1.5GHz ~ 3GHz)
  •          S21 dynamic range: 70dB(50kHz ~ 1.5GHz), 60dB(1.5GHz ~ 3GHz)
  •          RF output power: -9dBm
  •          Frequency tolerance: 0.5ppm
  •          Screen: 4.3″ IPS LCD, 800*480, RTP touchpad
  •          Operation via touch screen or 3 side buttons
  •          Battery: 3.7V Li-Po, 5000mAh
  •          Aluminium enclosure: 125mm x 75mm x 20mm
  •          SMA female RF port
  •          Sweep points: 101
  •          Calibration result storage: 5
  •          Calibration result interpolating supported
  •          Traces: 4
  •          Markers: 4
  •          Measures: S-parameter, VSWR, smith chart, phase, polar, etc.
  •          Mark table can be moved up and down
  •          Firmware upgrade via U-disk with type-c cable
  •          USB power output: 5V/1A
  •          Compatible with NanoVNA-saver, support screenshot

PartList

  •          NanoVNA-F V2 x1
  •          20cm SMA-JJ RG405 cable  x2
  •          Calibration kit: SMA OPEN/SHORT/50ohm LOAD
  •          SMA-KK adapter x1
  •          SMA-JJ adapter x1
  •          SMA-JKW adapter x1
  •          USB Type-C cable x1
  •          Stylus x1

 

Resources

Recently Viewed
If you’d like us to let you know as soon as this product comes back into stock, please enter your email address and mobile number below.
Yaesu
Icom