ZUM Radio-MMDVM for Pi. Rev 0.9

  Product is successfully added to wishlist.

ZUM Radio-MMDVM for Pi. Rev 0.9
£89.95 ( £74.96 EXC. VAT )
ESTIMATED SHIPPING COST:
£5.95
In Stock
Shipping to:
Add to cart
Product Information
  • Overview
  • Zum Radio RPI
Zum-radio control board MMDVM, connect to a radio with 9600Baud compatability "eg: ft7800, ft7900, ft8900, ftm100, ftm400 etc" and turn it into a multi mode digital node.

  • Designed for repeater and high power hotspot applications (Additional Hardware Required: Radio(s) and Raspberry Pi)
  • Fully assembled and tested full sized Pi format PCB, Mounts cleanly on RPI 2 and 3
  • Utilizes a high performance 32bit ARM processor running at 180Mhz (Room for future upgrades)
  • Fourth generation analogue filter design that provides an extremely low BER compared to previous generations
  • 2 Multi-turn pots for fine RX and TX adjustments
  • Status/Mode LED’s and (PTT, COS, Power, D-Star, DMR, P25, NXDN, Fusion)
  • Connections for Nextion LCD display and I2C LCD/OLED Display
  • 8 pin JST Connector with 150mm wires
  • Open source MMDVM firmware preloaded and easily upgraded by software


MMDVM Schematic:


Zum-radio control board MMDVM, connect to a radio with 9600Baud compatability "eg: ft7800, ft7900, ft8900, ftm100, ftm400 etc" and turn it into a multi mode digital node, or use two radios for a simple repeater.

You can also utilise a DR1 yaesu repeater for Dstar, C4FM, DMR, etc, a great project aimed at the more advanced radio enthusiast. 
Recently Viewed
If you’d like us to let you know as soon as this product comes back into stock, please enter your email address and mobile number below.
 
Product is successfully added to wishlist.
Yaesu
Icom