KiwiSDR - 10 kHz to 30 MHz Web Interface SDR Kit

KiwiSDR - 10 kHz to 30 MHz Web Interface SDR Kit
Part Number: KIWI-SDR-COMPLETE-KIT
RRP: £ 359.94
£284.95 ( £237.46 EXC. VAT )
ESTIMATED SHIPPING COST:
£5.95
In Stock
Shipping to:
Add to cart
Call Now
Product Information
  • Overview
  • Full Specifications

This Kit INCLUDES:
KIWISDR UK POWER SUPPLY - £10.95 
KIWISDR ENCLOSURE - £21.95
GPS Antenna
Beagle Bone (Green)
Kiwi SDR

PRODUCT DETAILS


KiwiSDR is a software-defined radio (SDR) covering shortwave, the longwave & AM broadcast bands, various utility stations, and amateur radio transmissions, world-wide, in the spectrum from 10 kHz to 30 MHz. The KiwiSDR is a custom circuit board (cape) that comes with a BeagleBone Green computer. It comes complete with a GPS antenna, power supply and network connection. It is supplied with software on a micro-SD card.

An HTML5-capable browser and internet connection will let you listen to a public KiwiSDR anywhere in the world. Up to four people can listen simultaneously to one radio — each listener tunes independently.

Try it right now! Listen to KiwiSDR registered on the rx.kiwisdr.com website.



Features:

100% Open Source / Open Hardware.

Browser-based interface allowing four simultaneous user web connections.

Each connection tunes an independent receiver channel over the entire spectrum.

Waterfall tunes independently of audio and includes zooming and panning.

Multi-channel, parallel DDC design using bit-width optimized CIC filters.

Good performance at VLF/LF since we personally spend time monitoring those frequencies.

Automatic frequency calibration via received GPS timing.

Easy hardware and software setup. Browser-based configuration interface.

Extension interface for adding decoders and utilities.



Specification

SDR covers the 10 kHz to 30 MHz (VLF-HF) spectrum.

Web interface based on OpenWebRX from András Retzler, HA7ILM.

Demodulation modes: AM, AMN, LSB, USB, CW, CWN, NBFM.

Extensions at present: WSPR viewer/decoder, IQ display, Loran-C viewer.

RF antenna connector: SMA and terminal block.

Integrated software-defined GPS receiver from Andrew Holme's Homemade GPS Receiver.

GPS receives the Navstar system on L1 frequency 1575.42 MHz.

GPS antenna connector: SMA, 3.3V powered for active antennas.

Voltage: +5V DC, 2.1mm jack, center pin positive.

Current: 1.5A including Beagle, KiwiSDR powers Beagle through header connectors.

Dimensions: KiwiSDR PCB 117mm * 55mm, SMA connectors additional.

Documents

For source code and issues list, please visit our Github page.

For technical discussion, please come to our Forum.
 Features
  • 100% Open Source / Open Hardware.

  • Browser-based interface allowing four simultaneous user web connections.

  • Each connection tunes an independent receiver channel over the entire spectrum.

  • Waterfall tunes independently of audio and includes zooming and panning.

  • Multi-channel, parallel DDC design using bit-width optimized CIC filters.

  • Good performance at VLF/LF since we personally spend time monitoring those frequencies.

  • Automatic frequency calibration via received GPS timing.

  • Easy hardware and software setup. Browser-based configuration interface.

  • Extension interface for adding decoders and utilities.

You Might be interested in
Recently Viewed
If you’d like us to let you know as soon as this product comes back into stock, please enter your email address and mobile number below.
Yaesu
Icom